Marine WIFI to go!

Low Cost, long range Marine WIFI.



  Our custom Marine WIFI is a proven long range system $718.00 !!!

     ( not including cables and fittings or shipping )  ( note, we do not do installation)


    and its not... two thousand dollars plus !!!!       put on you reading glasses if you need them and read on,

    there is a lot of reading material here on our low cost system.   We have satisfied customers who use this

    system very successfully in the Bahamas.    see info below regarding 15 dbi antennas from manufacturer.


   This is a complete bridge access system meaning any computer on board with wireless capability can use

   this system. Its not a one to one system !!!


    Marine  12 dbi  antenna with marine mount      $ 188.00   (rachet mount extra)




2400 - 2485 MHz


12 dBi


≤ 1.5



Vertical Beam Width


Horizontal Beam Width




Max. Input Power

100 watts

Lighting Protection

DC Grounded (reads short on Continuity Test)


1.32 lbs (0.6 kg)


41.33 inches (105cm)


N - Female

Radome Material

White Fiberglass (UV resistant)

Base Material

316 Grade Stainless Steel


Standard 1 inch - 14 Thread Marine Mount

Wind Survival

Up to 150 mph (241 km/h)


-40° F to 176° F (-40° to 80° C)

Product Warranty

The antenna is covered under a 5 year warranty against defects.  

Terminology Note: Due to various use of terminology, this antenna maybe referred to as: marine wifi antenna, marine wifi omni antenna, marine wifi omni directional antenna, rv wifi antenna, rv omni wifi antenna, marine 2.4 ghz omni antenna, marine 2.4 ghz antenna, marine 802.11 antenna, marine 802.11 omni antenna, outdoor marine omni wifi antenna. 


Do You Offer a 15 dBi Omni Antenna?
No. Actually as an engineering company, we must inform unsuspecting customers that a 15 dBi omni antenna only exists in marketing literature. It is not technically or pratically possible to build a 15 dBi model. Some companies offer antennas marketed as 15dBi. To prove our point, we bought samples of all of them, placed them into a testing laboratory and clearly none provided 15dBi gain. Some provided less than 11 dBi gain! Even if we could change the physics and make it possible, the vertical beam would be too narrow to be useful. We prefer not to use these type of marketing tatics and provide factual and truthful information. If you really need more gain, then you need an access point or router with more RF output power and better receiver sensitivity - see our high power access points or routers under the category of Radios. Or consider using semi-directional or directional style antennas, where the gain can be higher. For example, our supplier manufactures a 90 degree sector antenna with 17 dBi gain. Four of these would cover a full 360° radius.

     Outdoor waterproof coax amplifier.   $289.00


 Transmit Gain: Utilizing the latest Gallium Arsenide Heterojunction Bipolar Transistor (HBT), the unit provides highly linear gain of 22dB and full saturated output power of 33.0dBm.
LNA: The built-in Low Noise Amplifier with signal gain of 22 dB improves the receive sensitivity of remote equipment, while keeping noise level very low.
Receive Filtering: All radio equipment contain filter for receive path. The band pass filter on this amplifier gives added protection against out of band noise.
Power Cosumption: With only 5 watt of power consumption during max transmit and 0.25W during Rx, this product is the most efficient product available anywhere.
DC Injector: With only 1.2dB insertion loss, this DC injector is the lowest loss available anywhere. Enclosed in specially designed machined aluminum housing.

This set includes:
* The Outdoor Amplifier
* DC injector, and
* Universal power supply (110~240VAC to 6 V DC)


LMR-100 WiFi Pigtail    $22.95 plus shipping
These pigtails are required if you have a small antenna connector, such as on a notebook computer, or if you are attempting to adapt any coaxial cable with a pre-installed "N" type female connector. Our pigtails are manufactured out of quality LMR-100 coaxial cable, with heat shrink installed at the connector base.

All cables come with a type "N" Male connector and a connector of your choice. Please choose your connector carefully. We only offer pigtails in 12" maximum length to reduce coaxial line loss.



       Router - repeater





           $219.00 plus shipping



    $ 718.00 Total cost.    not inclusive of cables or fittings. plus shipping.





Wireless LAN (802.11g, 802.11b, Super G)

Standards Compliance

IEEE802.11b (Wireless LAN Standard)
IEEE802.11g (Proposed Draft Standard)

Frequency Range

2.412-2.462GHz (1-11 channel) 14 international

Transmission Rate

802.11g 108* High-Speed Mode™: 13, 20, 27, 40, 54, 80, 110, 125 Mbps
802.11g: 6, 9, 12, 18, 24, 36, 48, 54 Mbps
802.11b: 1, 2, 5.5, 11 Mbps


WPA2, WPA-PSK(AES, TKIP), 128/64-bit WEP,Wireless Power Output Setting, MAC Address Registration

Access Mode

Infrastructure Mode, WDS (up to 6 units)

External Antenna Connector


Selectable Channels

11 Channels (3 non-overlapping) 14 international

Communication Protocol

Direct Sequence Spread Spectrum (DSSS),OFDM

Wired LAN and Others


IEEE802.3 (10Base-T/100 Base-TX)

Transmission Rate

10/100Mbps (autosense)

LAN Ports / Connector

Four (4) 10/100 Base-T RJ-45 ports (Auto MDI/X) -1 port AP

Transmission Encoding Method

10Base-T Manchester coding:
100Base-TX 4B5B/MLT-3

Access Method


WAN Port / Connector

One (1) RJ-45 port

Power Supply

100-120V AC 50/60Hz DC 7.5v, 1.23A


W3xH6.75xD6.1 in. (76x171x155mm)


2 lb. (445g) Kit (shipping weight varies)

Operating Environment

0-40° C, 20-80% humidity (non-condensing)


   Note: USB system coming soon for smaller applications.